Hi, looking for some advice, when I first had FTTC enabled I was getting around 54mb and was pleased, I must be about 250m from the cabinet, anyway my dog kept knocking out the filter from the socket as the clip on the filter was broken, it took me ages to sort out properly and in the meantime my speed dropped down to 27mb guess DLM saw I poor internet connection and tried to account for it by reducing speed.
TalkTalk wont help because my speed is above the minimum that open reach say I could get - albeit slightly.
They replaced the router as they thought this would help, but didn't make much difference, this was mid April and since then my speed has increased back up to 35mb and my line has actually been solid, it stayed up for 21 days before the connection reset itself.
Looking at the stats below should I be worried about the interleave depth? is this something that I can raise a fault against?
DSL synchronization status:
Upstream line rate (kbit/s):
Downstream line rate (kbit/s):
Maximum upstream rate (kbit/s):
Maximum downstream rate (kbit/s):
Upstream noise safety coefficient (dB):
Downstream noise safety coefficient (dB):
Upstream interleave depth:
Downstream interleave depth:
Upstream line attenuation (dB):
Downstream line attenuation (dB):
Upstream output power (dBm):
Downstream output power (dBm):
This is what the ADSL checker says I should get..
VDSL Range A (Clean) 66.7 50.1 20 14 -- Available --
VDSL Range B (Impacted) 52.2 28.7 16.2 6.7 -- Available --
But before all my problems it said this..
FTTC Range A (Clean) 69.8 49.9 20 14 -- Available
FTTC Range B (Impacted) 60.1 35 19.9 9.7 -- Available