Yes! 1st do the following in your browser URL bar: http://192.168.0.1/setup.cgi?todo=debug
then you can manually telnet 192.168.0.1
However if you are after a more auto method, you may be interested in this, that I worked out.
Run this soon after Enabling Debug on the Netgear router (sometimes it times out):
TST10.EXE /R:NETGEAR.SCR /O:NETGEAR.OUT /m
(TST10 is a simple TELNET Scripting program) where NETGEAR.SCR contains:
SEND "adslctl info --show\m"
SEND "adslctl configure --snr 65536\m" /* COMMENT: Edit for reqd. SNR; this one is 0 */
I would have liked to parametrise that --snr figure but can't. Also looking at automating the Enabling Debug of router.
1999: Freeserve 48K Dial-Up => 2005: Wanadoo 1 Meg BB => 2007: Orange 2 Meg BB => 2008: Orange 8 Meg LLU BB => 2010: Orange 19 Meg Tweaked / 16 Meg Untweaked LLU BB