I'm connected but...

Well I decided to connect my second line to AAISP with the other to migrate once my O2 contract is up and it went live on friday but I'm struggling to get the routers setup correctly I'll list my setup below:

O2 - ST585V6 in Bridge mode - WAN1 on Draytek Vigor 2930
AAISP - Zyxel P660R-D1 in routed mode - WAN2 on Draytek Vigor 2930

Now with this setup like this using NAT it all works fine and both connections work but I can't get any of the machines behind the Draytek to work using one of my routed IP's from AAISP.

Will it work setup like this or do I need to be setting up the Zyxel in some sort of bridge configuation?

Have you tried asking on IRC?

irc://irc.z.je/A&A

One initial question occurs to me: What happens if you plug a PCs using one of the static A&A addresses directly into the Zyxel router rather than via the Draytek ?

If that works fine, I'd suspect the problem lies in the Draytek's configuration, if it doesn't I'd check the IP address block defined in the LAN settings on the Zyxel along with the Subnet and Default Gateway settings on the individual PCs.

Yes If I connect directly to the Zyxel router it works fine it just appears to be the config on the Draytek that is the problem, I'm not even sure it will work as it is, I've got a feeling the Draytek will need to have the WAN IP but I'm not certain.

Hi,

I have picked up your ticket that you sent to support, I will reply with a solution asap.