Query re Openreach FTTC Modem - One for Zarjaz?

What is the best way of disconnecting an Openreach FTTC modem please?

With ADSLmax, whichever way I do it - switching off on my DrayTek, switching off at mains socket; my BRAS always seems to suffer. Even requesting a reboot from the DrayTek control panel has upset it.

So just wondering the best way for switching off the OR modem - if there is one?



Many thanks.

Cheers!

Not sure if this helps or not - but I've switched mine off couple of times by pulling the mains plug out as I wanted the socket for something else temporarily - and each time I've plugged it back in my IP profile has returned to the 38717 it has always been.

I've unplugged the Modem to change over mains plugs on a 4-way distribution socket.

Also have had a few mains outages of upto an hour.

Didn't notice any speed degredation at all once the Modem was powered up again.

I have power cycled mine a few times - primarily to see if I can get back to the full sync! But each time I try the sycn comes back very close to where it was before power cycling.

1. Remove power connector
2. Remove line
3. Remove Ethernet connection to router

4. Wait a minute (or longer)

5. Reinsert power connector
6. Wait about 30 seconds until LED stops flashing (reboots itself with no incoming VDSL)
7. Reconnect phone line
8. Wait until DSL light stops flashing
9. Reconnect Ethernet


The reason for that is it allows the modem to be fully operational before connecting the line - and same with Ethernet. Just old fashioned practice - although modem systems can probably cope, I was taught to let one stabilise before connecting the next.

Using this on my FTTC and other ADSL connections has never resulted in any significant degradation/reduction in sync speed.

Interesting sequence there. I well remember having to keep to a tried and tested sequence when I was using either a GSM phone or a INMARSAT-A terminal for access to the C&W Easylink service using my Win95 laptop; luckily I used a DOS based program and it was text characters only, which made for a shorter/cheaper transmission.

Recently found that on rebooting my DrayTek V2800 that it would not let access the user interface on http://192.168.1.1 unless it was connected to the phone line, odd to say the least.

Cheers!

Used your steps and the profile on BT speedtester went up to 23317 from 23179

In other words I gained 0.5%

Sorry Clive, only just spotted this thread, it's almost as if it has my name on it !!!

I'm with MHC, disconnect the router, then power down the VDSL modem. In reverse, let the modem sync up before reconnecting the router.

I must admit, it seems not to have any detrimental effect on my circuit however I do it. I do tend to leave it on 24/7 as a rule.

Thanks Zarjaz and MHC

I hope to go FTTC end of September subject to Hawarden being ready. Although I will be going with A&A I thought best to ask here since BT Infinity seems to be the best known product and of course the kit is identical.

Now if I could only fathom out why OR have spent resources marking up the location of their cable ducts (paint marks on pavement). The fibre between cabinets does not pass this way, so cannot be for that. I'm hoping that OR are either going to fit a brand new cabinet + FTTC cab, or FTTP like at Chester South - the next exchange area to the east from Hawarden. However I think both of those wishes are unlikely

Thanks again.

Cheers!

What's your postcode? I can check the spreadsheet.

But you did not lose anything! And that was the point ... not to gain but to stop significant losses.