Vigor 2850 Setup elp

Still having issues with my Draytek 2850
Firmware is 3.62
I want to use the White Openreach Modem and the 2850 together
I have set the Username correctly
VLAN TAG is set to 101 for VDSL
WAN2 used for BT Infinity

Looks like i can connect when using Line directly to the router see below
but no internet access

Is there an idiots guide somewhere


VDSL >> VDSL Status

--------------------------------------------------------------------------------
Auto-refresh VDSL
Link Status Showtime
Firmware Version 1412f0
Basic Status Upstream Downstream Unit
VDSL Profile 17a
Actual Data Rate 11999 63598 Kb/s
SNR 88 64 0.1dB
Advance Status Upstream Downstream Unit
Actual delay 0 0 ms
Actual INP 0 0 0.1 symbols
Actual INP 0 0 0.1 symbols
15M CV 1 0 counter
1Day CV 13570 10 counter
15M FEC 0 0 counter
1Day FEC 2593645 780 counter
Total FEC 2593645 780 counter

Have you tried

http://www.draytek.co.uk/support/kb/kb_vigor_v2850_s...

You have two FTTC lines?

No Just one
Have tried the Mikey Guide but no Luck
Have checked the time on the 2850 and its ok
One thing to Note
I connect the OR Modem to the 2850 on the WAN Port
But only get one Led ( Left ) Lit on the Port
have tried other Cables and Other Ports where as when i connect a port to the PC i get both leds lit
tried resetting th OR Modem same result

In reply to a post by G1NZO:

I connect the OR Modem to the 2850 on the WAN Port
But only get one Led ( Left ) Lit on the Port
have tried other Cables and Other Ports where as when i connect a port to the PC i get both leds lit
tried resetting th OR Modem same result

Try setting the port speed on the 2850 to 100megabit full duplex rather than auto negotiate.