What time of day are you testing?

I am also on the Entanet 80/20 product and when complaining of speeds was rather horrified to find that to get the maximum my setup was capable of I had to test between about 8:30pm and midnight. Before 8 Business has priority and after 12 it is a free for all. Home users have priority from 8:00 to 12:00. It certainly makes a huge difference particularly to download speed on my line. In fact hardly worth paying the little extra for the 80/20 service as during the day I rarely get more than 40.

Edited by philippercival (Wed 13-Jun-12 09:42:06)

this happened 2 days ago nothing has changed at my house . i just noticed that my speeds had dropped i have had fttc for over 1.5 years and been on 80/20 for over a month with max sync then this !

Its not my sync rate thats the issue is the attaianble sync rate its gone from 79999/30000 to 46407/19403 and has not increased since i have run my retests at 06:00am / 5pm / 12pm make no difference the line throughput has veen cut in half. i have posted what my lines stats were a month ago and what they have dropped to now .

Do you happen to have pbParams data from when your attainable rates were at the maximum - for a "before & after" comparison (especially attenuation).

If attenuation has actually increased by a lot, it would definitely indicate a physical line and/or filtered faceplate fault (IMO).

If you don't have that data, maybe someone could compare stats with you who is a similar distance from the cabinet as you.
Did you mention line length earlier?

There is always noise on the line - across the full spectrum. It will continuously vary in amplitude at different frequencies - not always by very much but something can happen - and suddenly a band of noise see a large increase.

My attainable upstream has risen to 52888 tonight so not sure if it's resyncing or not ?

In reply to a post by truex360:

My attainable upstream has risen to 52888 tonight so not sure if it's resyncing or not ?

??? Should that have read attainable downstream?

Attainable rates ususually fluctuate up/down roughly in line with SNRM i.e. if SNRM increases, Attainable Rate usually also increases.

It does NOT necessarily mean the connection has resynced.


EDIT:

Just to ask again:-

Do you happen to have pbParams data from when your attainable rates were at the maximum - for a "before & after" comparison (especially attenuation).

If attenuation has actually increased by a lot, it would definitely indicate a physical line and/or filtered faceplate fault (IMO).

Edited by Bald_Eagle1 (Wed 13-Jun-12 19:38:26)

not sure how to read these stats but it says retrain reason : 2 was 0 before ? notice power has increased as well anyone welcome to point out the key stats or differences from my last posted stats

[IMG]http://i713.photobucket.com/albums/ww132/truex360/pb...[/IMG]

[IMG]http://i713.photobucket.com/albums/ww132/truex360/pr...[/IMG]

Retrain Reason 0 = forced resync e.g. a reboot/power cycle
Retrain Reason 2 = unforced resync e.g. DLM initiated resync

i have got an engineer visit tomorrow so i will update.

Edited by truex360 (Fri 15-Jun-12 16:16:30)