In reply to a post by Zarjaz:

Kellys told you that ... where is the salt?

Indeed ..... bunch of pillocks.

I was trying to be polite

It's BT that decided the faceplates with screws need changing not Kellys..

In reply to a post by Stevesdad:

It's BT that decided the faceplates with screws need changing not Kellys..

Has anyone suggested anything different?

I've just moved from a Mk2 to a Mk3 on my ADSL service and the SNRM is higher and appears to fluctuate less too. After a resync, sync rate is a little higher too. I'll monitor to see if the improvements are sustained...
Off topic but, I have an unlocked Eircom F1000 that I've just configured to run as a modem only so will install that at some stage to look for further improvement.

This is all in preparation for migrating to fibre (everything crossed) in December.

Paul

In reply to a post by youngsyp:

And so mixed that you can only rationally take the comments/ experiences on face value.

As I understand it, you'll only really see any difference/ improvement if you're currently suffering from some sort of REIN, as it's just a filter change.

Paul

Blast, this is the post I should have quoted/ replied too.

Paul

I had a recent install 10 days ago but they put in a MK2 rather than an MK3. I guess both are still used?

It's BT that decided the faceplates with screws need changing not Kellys..

Yes, but if anyone pays attention, they don't say that the screw terminal NTE's need to be swapped out unless faulty.