HG612 Unlocking - g.imp issue

Does anybody have a link to the correct firmware needs for unlocking a HG612?

Ive read that to be compatible with the g.imp thing the firmware version has to end in a xxxxx08, however I can only find one ending in xxxxx10 on the Kitz website.

Check this post.

http://forums.thinkbroadband.com/fibre/t/4399245-re-...

Its not the 10 or 08 you need to be looking at but 10 is the right one that you need

Edited by Seansmit17 (Wed 24-Jun-15 09:41:38)

Noooooo Sean.

Not easy for me to find the right one, using an iPad in bed, but the 10 is base 28 and doesn't support G.INP. The 08 is base 30 and does. Read the full version numbers.

I'll find it for you later, unless hopefully someone else does in the meantime.

Read the whole of the thread that is linked to by seansmit ... and as robertos says ...030SP08


Go to: https://mega.co.nz/#F!LdJFDIJL!e_E1twsIg2kTet8mPjrb4w

and you will see a list of three folders, select the B030SP08 folder and within that are three files original, unlocked, webgui - I used the third one and have access via Telnet and the Webgui.

I also set the IP address under Basic; LAN; to be a specific value say 192.168.1.234

Connect LAN2 to your router or switch and you can then access at will, knowing the IP address.

Edited by MHC (Wed 24-Jun-15 10:18:29)

SP08 is the correct one yes!

https://mega.co.nz/#F!LdJFDIJL!e_E1twsIg2kTet8mPjrb4w

snap - editing my post when you posted this!

My bad I did mean to say 08 but after a night at work my brain don't work so well

Thanks all

I got the unlocked firmware and I have followed the process to flash it to the modem.

Problem is now after uploading the new firmware to the device after a while I just get 'page cannot be display'.I can still ping the modem.

Almost seems as if it is not unlocking?