DSLStats

I have been having a few problems with fibre lately. To the point I have swapped out all of my kit and even built a pfSense router.

Having put my trusty HG612 back on the line I can see the stats on the line. It doesn't mean too much to me but I did notice the high number for the interleave:

Stats recorded 28 Sep 2016 21:13:30

DSLAM/MSAN type: IFTN:0xb206 / v0xb206
Modem/router firmware: AnnexA version - A2pv6C038m.d24j
DSL mode: VDSL2 Profile 17a
Status: Showtime
Uptime: 9 hours 5 min 25 sec
Resyncs: 0 (since 28 Sep 2016 21:03:42)

Downstream Upstream
Line attenuation (dB): 14.5 0.0
Signal attenuation (dB): Not monitored
Connection speed (kbps): 63545 20000
SNR margin (dB): 6.2 12.1
Power (dBm): 5.7 5.7
Interleave depth: 1243 1
INP: 3.00 0
G.INP: Not enabled Not enabled
Vectoring status: 5 (VECT_UNCONFIGURED)

RSCorr/RS (%): 0.0060 0.0015
RSUnCorr/RS (%): 0.0000 0.0000
ES/hour: 0 0

Is there anything obvious I am missing? ISP is still investigating slow downs etc.

Cheers

Skilty

Edited by Skilty (Wed 28-Sep-16 22:04:28)

You're connected to an ECI cabinet, so no G.INP at the moment.

In reply to a post by BatBoy:

You're connected to an ECI cabinet, so no G.INP at the moment.

Nope but my interleave has jumped from around 16 to 1243...

Now it could be because I was asked to switch the modem, the cable to the socket and then I changed the MK3 faceplate to eliminate that as a potential issue.

I think interleaving is added in response to errors. The SNR margin would be raised in response to disconnections.