I don't think my master socket haven't got any spare cable left?

Last time engineer only put two wiring on my master socket incoming from exchange is blue and orange. Nothing else. https://ibb.co/Wp78kbL & https://ibb.co/fHBHZbv

Is that brown and green use for 2nd new line?

Edited by adslmax (Fri 16-Oct-20 15:07:55)

And the unused pair ...?

In reply to a post by RobertoS:

And the unused pair ...?

Is that mean Brown and Green are unused pair (for 2nd new line)?

Yes, that is a spare pair that the engineer would most likely use for a "new" line.

In reply to a post by ian72:

Yes, that is a spare pair that the engineer would most likely use for a "new" line.

Ok so the estimate for G.fast will be much the same then? But more likely FTTC line might reduced VDSL sync rate?

Edited by adslmax (Fri 16-Oct-20 15:19:46)

One cannot say with any absolute certainty until a signal is on the line

My isp told me for my line G.fast could be range from 112 to 224 but it can't known until it active on the day of installation but told me if it fail below 112 then the engineer might likely to rejected G.fast to go live and cancel it. Next door got G.fast getting 215 down and 37 up so more likely I can get full 160/30 with no issues.

Edited by adslmax (Fri 16-Oct-20 15:30:26)

Why not tell us the ISP?

In reply to a post by RobertoS:

Why not tell us the ISP?

BT on Fibre 100 as BT ISP told me can't order Fibre 250. Only Fibre 100.

Edited by adslmax (Fri 16-Oct-20 15:43:52)

Are BT Fibre 100 come with Openreach Modem or BT Hub? Does BT Hub support G.fast?