Connecting Gigaset N300IP Base to Hyperoptic ZTE Router

Good morning all
I apologise if this has been dealt with before but I cannot find a thread dealing with the issue.
I have Hyperoptic service to my apartment with a Hyperoptic-supplied ZTE Home Gateway ZXHN H3600
I need to replace my phone as part of the set-up and have acquired a Gigaset C570HX with N300IP Base. I am completely at a loss with regard to installing and pairing the Gigaset Base with the router.
Any assistance / insights would be greatly appreciated

In reply to a post by Richard_C:

I need to replace my phone as part of the set-up and have acquired a Gigaset C570HX with N300IP Base. I am completely at a loss with regard to installing and pairing the Gigaset Base with the router.

You simply use an ethernet cable to connect the N300 to your router, once connected it will get an IP address via DHCP (on your router) and you then just have to login to the N300 and configure it with your required VOIP service.

Thanks for the swift response - I will try it a bit later. Much appreciated