Cisco Linksys X2000

Just wondered if anyone has managed to configure one of these units and get is working with O2 Broadband.

I've set it to:

Auto, ADSL,
RFC 2684 Bridged
VPI: 0
VCI: 101
ADSL Mode: Auto
MTU: 1500
Multimode
Hostname: O2 Home Broadband

I get an up/downstream but no IP values are assigned.

I have a Netgear DGN2000 working fine and also Wireless O2 box so any further help would be welcome.

Thanks

is 0/101 still correct?
I beleive that other Be wholesale lines are provisioned PPPoA VPI/VCI 0/38 (ie the same as BTW) now by default.

As far as I'm aware it is and what O2 suggested, selecting PPPoA requires a username/password which O2 does not use.

You can see the settings available here http://ui.linksys.com/files/X2000/1.0.00/

Ah OK - not familiar with the specifics for O2

Just wondering if you had any luck looks like i am having the same issues on BE i use a Static IP and ANNEX M although i get up/downstream i cannot get on the internet

used belkin and netgear in the past without an issue

In reply to a post by Trevvie:

Just wondering if you had any luck looks like i am having the same issues on BE i use a Static IP and ANNEX M although i get up/downstream i cannot get on the internet

used belkin and netgear in the past without an issue

Didn't get a chance to last night but will be trying again this evening. The previous night Linksys called me and they couldn't get it working either. If I can't get it going tonight it looks like it will be going back for refund. I recall reading a thread somewhere about chipsets that O2 supported but can't recall how old the post was.

I'm not sure if this is correct or not but all Linksys products only support Annex M (from what Linksys support have advised), O2 is Annex A but I've seen WAG320N's working with O2 so I'm baffled.

i am using Annex M and it does not work on that either unfortunately I have not had any time to look at this any further over the weekend

I'm not sure if this is correct or not but all Linksys products only support Annex M

This cannot be true, I have seen plenty of them working on annex A lines.

Suspect they've got things the wrong way around, Annex M is rare so only supporting that and not the standard mode would be commercial suicide