VOIP and BT Infinity 2 traffic shaping :: BT Broadband

User comments on ISPs
>> BT Broadband

Pages in this thread: 1 | 2 | 3 | [4] | (show all)

Print Thread

jchamier
(knowledge is power) Wed 12-Dec-12 22:27:07

Re: VOIP and BT Infinity 2 traffic shaping

[re: RobertoS] [link to this post]

In reply to a post by RobertoS:
In reply to a post by jchamier:
... we have no need for the "business add ons" that BT are selling.
What about the faster fault fixing?

Nope, we don't need that - if its out for 3 days or so we are ok. They won't do a real service level on any of the products.

(This is for a test/dev system, not our corporate internet).

James BT Infinity 2 19/09/2012 - Estimate 44.6/6.5 - Install 52/12 - Actual 46 / 8 Mbps
_{13 years of broadband - 1999 ntl:(512k/1M)/BTbusiness(2M)/Metronet(2M)/Bulldog(8M/16M)/BE(19M/16M)/BT FTTC(46M)}

MHC
(sensei) Wed 12-Dec-12 22:29:00

Re: VOIP and BT Infinity 2 traffic shaping

[re: jchamier] [link to this post]

In reply to a post by jchamier:
Not noticed any difference in the IP connection apart from my domestic Infinity is capable of higher speeds.

That is due to the line, not the service.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

M H C

taurus excreta cerebrum vincit

deleted
(deleted) Wed 12-Dec-12 22:50:22

Re: VOIP and BT Infinity 2 traffic shaping

[re: jchamier] [link to this post]

In reply to a post by jchamier:
In reply to a post by BatBoy:
All I can say is what happened to my connection and the steps I took to fix it. The bottom line is that I noticed TR069 entries on my router log corresponding to when my speed was reduced. I stealthed the open port on the modem and I haven't had a slow down since. I asked BT but received no response.

I wonder if that's an artefact of using the Huawei as a router - rather than the Huawei passing PPPoE through itself from the external router. Could be a Huawei firmware issue perhaps.

Unlikely, as that was part of the solution rather than the problem.

Pages in this thread: 1 | 2 | 3 | [4] | (show all)

Print Thread

Jump to