Hmm.

As far as I know, the only config available is in the original post.

The nearest I've found is:

>show net wan uprate
uprate unlimited

>show net wan downrate
downrate unlimited

But I suspect this relates to the bandwidth management, which I believe is switched off.

Support has been poor - I think they intended these routers to be provided by ISPs, and don't want much to do with them now they're in the wild.

I guess they should have re-badged them!

I'll go through the manual & release notes again, but I don't think it's covered...

it's in the CLI ref manual, as one would expect.

info adsl parameters

aha - thanks for this.


The output means next to nothing to me, other than to confirm the uplink of only 7101kbps:

adsl:
parameters:
Tx line rate: 1145 kbps
Rx line rate: 7101 kbps
Tx Power:
Local: 12.3 dB
Remote: 20.5 dB
Line Attenuation:
Local: 37.5 dB
Remote: 19.5 dB
SNR Margin:
Local: 16.5 dB
Remote: 6.5 dB
Self Test: Passed
DSL Standard: ADSL2/2+
Trellis Coding: Disable
Framing Structure: Unknown
Operation Mode: Showtime/Data
device:
Running Firmware: SW2.0.6a
Primary Firmware: SW2.0.6a
Backup Firmware: SW2.0.6a
Hardware Version: 810100
ipoa-ip:
Failed to get IPoA interface ip.

you could try

set port adsl trellis enabled

which may help the speed. Also

set port adsl standard adsl2plus

is worth a go

manual here

I think i've pretty much chenged every adsl setting available now, though I'm obviously hacking away blindly.

Whatever i try, the TX won't go over 7104...