Technical Discussion
  >> DSL Hardware Discussion


Register (or login) on our website and you will not see this ad.


Pages in this thread: 1 | 2 | [3] | 4 | (show all)   Print Thread
Standard User shaneosborne
(experienced) Tue 07-Feb-12 17:06:39
Print Post

Re: New Router - To improve connection/speed(s)


[re: deleted] [link to this post]
 
It's done something because it was previously 7.1db and I know Sky's Kit locks it at 7db crazy

My Broadband Speed Test
Standard User shaneosborne
(experienced) Tue 07-Feb-12 18:25:19
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
I've solved it, it must be something Skys end blocking this...

I called Sky and asked them if they could release the capp on my line as it was set to 16mb, I wasn't aware Sky set a cap but they do after initial training.

Now that I check my Router, the snr is down to 1.3 and im syncing at 19661. It's been working solid for 30mins but i'll keep an eye on it tonight..

So, the conclusion is that Sky must have done something there end to stop the snr tweak to work. Does this make sense to anyone? Previously, my line was capped and I was always syncing at that rate so perhaps thats why I couldn't see any change.

They said that if I want them to change it again later then to phone and they will see what they can change it too. I obviously didn't tell them about my new router and snr tweak blush

My Broadband Speed Test
Standard User shaneosborne
(experienced) Tue 07-Feb-12 18:26:16
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
SNR is set to 1

In reply to a post by shaneosborne:
I've solved it, it must be something Skys end blocking this...

I called Sky and asked them if they could release the capp on my line as it was set to 16mb, I wasn't aware Sky set a cap but they do after initial training.

Now that I check my Router, the snr is down to 1.3 and im syncing at 19661. It's been working solid for 30mins but i'll keep an eye on it tonight..

So, the conclusion is that Sky must have done something there end to stop the snr tweak to work. Does this make sense to anyone? Previously, my line was capped and I was always syncing at that rate so perhaps thats why I couldn't see any change.

They said that if I want them to change it again later then to phone and they will see what they can change it too. I obviously didn't tell them about my new router and snr tweak blush


My Broadband Speed Test


Register (or login) on our website and you will not see this ad.

Standard User shaneosborne
(experienced) Tue 07-Feb-12 18:35:46
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
What I done for changes to take affect (in case other Sky Customers are having issues)...

Changed my SNR Value to 1

Emailed Sky who then phoned me back within 5 mins (very quick for Sky)
They then checked to see what my line would support and they supprisingly said your line has all of a sudden started to suport a max rate of 22MB.

They asked me to switch of my router whilst they changed this. They said they couldn't set it to 22MB as the line synced at 19 so the sytem asks for that value and then it's capped.... I said " can you just set it at the max and she said welllllll not really" so she could but didnt want to. Now when I check my router the snr changes are showing as before they didnt...

Why? I have no idea....

In reply to a post by shaneosborne:
SNR is set to 1

In reply to a post by shaneosborne:
I've solved it, it must be something Skys end blocking this...

I called Sky and asked them if they could release the capp on my line as it was set to 16mb, I wasn't aware Sky set a cap but they do after initial training.

Now that I check my Router, the snr is down to 1.3 and im syncing at 19661. It's been working solid for 30mins but i'll keep an eye on it tonight..

So, the conclusion is that Sky must have done something there end to stop the snr tweak to work. Does this make sense to anyone? Previously, my line was capped and I was always syncing at that rate so perhaps thats why I couldn't see any change.

They said that if I want them to change it again later then to phone and they will see what they can change it too. I obviously didn't tell them about my new router and snr tweak blush


My Broadband Speed Test
Standard User deleted
(deleted) Tue 07-Feb-12 18:51:42
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
IMHO 1db is a bit too low, i prefer to keep the downstream SNR between 2 & 3 on my 7800N, that way at least you've still got a bit of leeway. These are the values you should use to adjust the SNR on your 7800N:

go to http://192.168.1.254/snr.cgi
and enter one of the values below and save.

standard values are.
200 = +6dB
150 = +3dB
100 = +0dB
50 = -3dB
25 = -4.5db
1 = -5.5dB

The command does not accept negative numbers. However the command can be tricked into accepting negative numbers by entering high positive numbers.

65500 = -9dB
65480 = -9.5dB
65450 = -12dB
Standard User Oliver341
(knowledge is power) Tue 07-Feb-12 18:55:43
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
In reply to a post by shaneosborne:
So, the conclusion is that Sky must have done something there end to stop the snr tweak to work. Does this make sense to anyone? Previously, my line was capped and I was always syncing at that rate so perhaps thats why I couldn't see any change.

Sky have always had synch caps aka line profiles in operation as far as I know. The DLM which runs on day 1 sets this cap. Once the synch cap is set it's locked unless Sky staff manually raise it, or DLM is re-run. The value it's locked at is in your Sky control panel, although it will not reflect manual alterations.

Oliver.
Standard User Tacitus
(experienced) Tue 07-Feb-12 19:05:45
Print Post

Re: New Router - To improve connection/speed(s)


[re: deleted] [link to this post]
 
In reply to a post by aramsay:
I've put together some Cacti templates that you can download too (if you use Cacti) which will allow you to monitor your SNR, throughput, etc.
You appear to be knowledgeable about tweaking the 7800, but do you know if the same figures also apply to the 7700, or is that one not tweakable?
Standard User shaneosborne
(experienced) Tue 07-Feb-12 19:35:18
Print Post

Re: New Router - To improve connection/speed(s)


[re: deleted] [link to this post]
 
I've decided to change the value as you stated, i've set the value to 25 and my line states are below;

ADSL Status

DSP Firmware Version: A2pB025f.d22k
DMT Status: No Defect
Operational Mode: ADSL2+
Upstream: 768
Downstream: 18848
SNR Margin(Upstream): 8.9
SNR Margin(Downstream): 2.5
Line Attenuation(Upstream): 11.0
Line Attenuation(Downstream): 21.5
========================================

It's a shame my UPLOAD speed seems low, in fact it has always remained low. When I spoke to sky they said they could change it from the 1MB it's set but this still seems low....

I would like to thanks all of those who have replied, many thanks all.... smile



In reply to a post by baby_frogmella:
IMHO 1db is a bit too low, i prefer to keep the downstream SNR between 2 & 3 on my 7800N, that way at least you've still got a bit of leeway. These are the values you should use to adjust the SNR on your 7800N:

go to http://192.168.1.254/snr.cgi
and enter one of the values below and save.

standard values are.
200 = +6dB
150 = +3dB
100 = +0dB
50 = -3dB
25 = -4.5db
1 = -5.5dB

The command does not accept negative numbers. However the command can be tricked into accepting negative numbers by entering high positive numbers.

65500 = -9dB
65480 = -9.5dB
65450 = -12dB


My Broadband Speed Test
Standard User deleted
(deleted) Wed 08-Feb-12 05:31:41
Print Post

Re: New Router - To improve connection/speed(s)


[re: shaneosborne] [link to this post]
 
In reply to a post by shaneosborne:
I've decided to change the value as you stated, i've set the value to 25 and my line states are below;

ADSL Status

DSP Firmware Version: A2pB025f.d22k
DMT Status: No Defect
Operational Mode: ADSL2+
Upstream: 768
Downstream: 18848
SNR Margin(Upstream): 8.9
SNR Margin(Downstream): 2.5
Line Attenuation(Upstream): 11.0
Line Attenuation(Downstream): 21.5


Dude that sync speed is a little on the low side for a 21 db attenuation...have you checked your wiring, changed filters, tried plugging router into test socket etc etc?
Standard User shaneosborne
(experienced) Wed 08-Feb-12 08:18:30
Print Post

Re: New Router - To improve connection/speed(s)


[re: deleted] [link to this post]
 
I've tried everything with no success, it's just my damn upload which is low and have no idea why when it's set higher at Sky's end crazy

Pages in this thread: 1 | 2 | [3] | 4 | (show all)   Print Thread

Jump to