@ Moradin

Does seem odd. Will walk up there and have a listen to see if it has been powered on.
Spoken to BT today on the phone and they are still saying Infinity isn't available.

Does seem a bit odd but perhaps it's about to go live.

Quick question if i may, while looking at the current list my postcode CA1 3NZ does not show up however the phone lines for us go to a pole that carrys the phonelines for several houses on the other side of the road as well which is listed (postcode CA1 3LW).

Does this mean i can still order when it go's live or because my postcode isnt in the database they will say no??

AndyC

Well, you are on cab 93 which on the latest list is Planned for FTTC in Phase 8a, so yes you should receive FTTC when it's ready.

AndyC.. not sure what list you checked. but as James states:-

LCCAR CARLISLE CA13LW {LCCAR}{P93} 0 100% 9.19 8a Yes

In reply to a post by Moradin:

AndyC.. not sure what list you checked. but as James states:-

LCCAR CARLISLE CA13LW {LCCAR}{P93} 0 100% 9.19 8a Yes

Of which their current expectation is 80% of all planned cabinet roll outs in Carlisle to be completed by 20 th June, with the initial switch ons to be started in mid may.

Does anyone have experience of Telent working practices when installing cabs in a town?

There are about 17 cabs on the document to be done around Epping. Telnet was busy installing several around town in the week after New Year and I have spotted 7 in-situ. However they now seem to have disappeared. My cab hasn't appeared next to the PCP yet even though there is a (now faded) paint mark up on the pavement where it should be going.

So I'm naturally concerned that there are issues preventing installation of my cab. It is still on the checker as 31st March however. Do Telent tend to just disappear off a job like this mid way through?

Guys, there's a couple of things to remember with postcodes and exchanges - postcodes can be used to identify cabinets in most cases, but on checkers they are not reliable. If your postcode is 100% on a cab, then fibre and power are required to that cab along with the exchange being RFS. If your cabinet is on the sheet as deployed etc and the exchange is RFS don't make the mistake of thinking that's it and FTTC is just around the corner, it may not be mainly due to delays in comissioning your cabinet (power etc).

The phone number checker is always king here!

I think it's time this thread was closed, partly because it has pretty much served it's purpose but mainly because of its length!

If anyone has anything further to add to the subject, or questions about any particular aspect, feel free to start a new thread with a link back to the appropriate post in this one.

Closed.