In reply to a post by adslmax:

Funny one person say from ocuk forum that my line stats look awful and need to raise openreach / isp. He probably jealous?

Sounds like the person on OCUK is trolling you

In reply to a post by WWWombat:

Depressingly good statistics.

Zero CRC errors downstream in 9.5 hours.

It now 8 on CRC errors downstream after 14 hours (street lightning might cause this) it jump from 0 to 8 after 5pm. But, it stay at 8 ever since.

http://postimg.org/image/x8dwxq9xt/full/

Those stats look very strong. I can't see crosstalk having an impact on your sync speed at all.

I've noticed a few more HomeHub 5's appearing in my wireless network list. My max attainable rate is gradually dropping as more lines are hooked up to the cab.

In reply to a post by wolvesmad:

Those stats look very strong. I can't see crosstalk having an impact on your sync speed at all.

I've noticed a few more HomeHub 5's appearing in my wireless network list. My max attainable rate is gradually dropping as more lines are hooked up to the cab.

I had dumped BT Home Hub 5 because it rebooting itself last night until I read from BT Community Forum that peoples complaint of BT Home Hub 5 rebooting every night (checking firmware) that's has put me off. I went back to BT Openreach Modem HG612 (unlocked) with Netgear DGND3700v2 Router and it now ongoing stable for 14 hours and these should avoid any rebooting itself.

Wolvesmad is your BT Home Hub 5 rebooting itself last night? U can check it under helpdesk log file.As you don't want to see your BT Home Hub 5 rebooting every night that might trigger your DLM.

Edited by adslmax (Sun 16-Feb-14 19:29:41)

No it seems to have been up for nearly 4 days now. I'm not particularly happen with the wireless performance of it though. Only getting about 50Mb over wifi.

They are good and you know they are

especially as his attenuation is very close to mine yet I have an attainable almost 40mbit lower on the downstream.

openreach have openly told my isp they wont be doing a pair swap or any other kind of cabling change on the basis that other circuits "will" degrade, that comment suggests to me my d-side is broken if they know before hand other circuits will degrade from such work. This was after an engineer admitted to me is probably cabling issues but he didnt want to be bothered to look for them instead telling me I have to wait for the line to practically stop working so the tester units pick it up.