Where did you get the latest firmware from?

Hi was just in process of replying...

https://mega.co.nz/#F!LdJFDIJL!e_E1twsIg2kTet8mPjrb4w

You can find it at the link above, you have 3 options..

Original = Locked
Unlocked = Unlocked (No access to web gui but can be read via telnet)
Web Gui = Unlocked with Full access to Web Gui & Telnet

Install process is same as original unlocking

In reply to a post by Ignitionnet:

In reply to a post by Chrysalis:

yeah I just posted this on the plusnet forum, as aaisp have made a complaint to BTw about latency increases which in my view is down to incompatible devices. As you said g.inp at least on some devices when it wont work falls back to interleaving.

I've just been talking to A&A and given them some information. I hit this issue myself earlier today.

you got your before and after stats?

In reply to a post by Chrysalis:

you got your before and after stats?

Largely by chance yes, as do they.

can we see them here?

Thanks. I've switched from the ECI modem to the HG612 3B running the latest firmware. I'm back on fast path, and upstream sync has increased by a couple of megabits, which is nice.

In reply to a post by ip75:

In reply to a post by Tacitus:

...and via Telnet all this can tell me is the DSLAM chip is Broadcom.

I *think* this means it's a Huawei cab.

I have a feeling you are correct, so It looks as though G.INP will be enabled by the end of next week. I'll have to check over on the Draytek site as to whether the current firmware is G.INP 'friendly'

In reply to a post by Zadeks:

Thanks. I've switched from the ECI modem to the HG612 3B running the latest firmware. I'm back on fast path, and upstream sync has increased by a couple of megabits, which is nice.

That's good!

Glad I could help!

In reply to a post by Tacitus:

Bit tangential to this thread, but how do I find out if my cab is Huawei or ECI?

If you know where your cabinet is, see these pictures. (The 128s should be labelled 96 I think but I keep forgetting to alter them).

In reply to a post by RobertoS:

In reply to a post by Tacitus:

Bit tangential to this thread, but how do I find out if my cab is Huawei or ECI?

If you know where your cabinet is, see these pictures. (The 128s should be labelled 96 I think but I keep forgetting to alter them).

I know for sure which cabinet I'm on as it's just down the road and the ISP (iDNet) confirmed I'm on that one. Not checked if there's any 'model/type' number on the cabinet, but from the pictures it's definitely a Huawei 288.

As I said earlier the Draytek reports that the DSLAM chipset is a Broadcom. Since Drayteks use Lantiq, the best I can expect is that it's G.INP 'friendly'. Certainly until they start releasing updated firmware.

I've got a Zyxel SBG-3300 knocking about which uses a Broadcom chip, so it might be worth trying that and see what happens.