Who mentioned lower latency ? the issue was with ECI on HUAWEI cabs causing increased latency and lower sync speeds due to incompatible firmware and G.INP :/

In fact, "considerably increased latency" and "considerably lower sync speeds" .

I don't know if it's been said, but the same applies to HG612's that haven't been updated. Such as the one I got the other day from OR van stock when mine failed.

Oh dear...connected an unlocked HG612 (fw B030SP08) to replace my ECI modem and speeds & ping are still the same Instead of syncing at 80000kbps like i was a few weeks ago & with ping times of 25ms, i 'm still getting ~65 meg and with pings of nearly 40ms.

Based on my stats i should be synced at the full 80 meg, correct?

http://www.imageupload.co.uk/image/ZEEQ

It seems my cab (100% sure its Huawei) has not had G.INP applied as i don't see Bearer 1 in stats so therefore my loss of speed is probably down to crosstalk.

I thought all Huawei cabs had been upgraded to G.INP at end of March?

http://www.imageupload.co.uk/image/ZE4B

Please post the output from cmd: xdslcmd info --pbParams

# xdslcmd info --pbParams
xdslcmd: ADSL driver and PHY status
Status: Showtime
Retrain Reason: 0
Last initialization procedure status: 0
Max: Upstream rate = 31957 Kbps, Downstream rate = 83368 Kbps
Bearer: 0, Upstream rate = 19999 Kbps, Downstream rate = 68579 Kbps

Discovery Phase (Initial) Band Plan
US: (7,32) (871,1205) (1972,2782)
DS: (33,859) (1216,1961) (2793,3970)
Medley Phase (Final) Band Plan
US: (7,32) (871,1205) (1972,2782)
DS: (33,859) (1216,1961) (2793,3970)
VDSL Port Details Upstream Downst
ream
Attainable Net Data Rate: 31957 kbps 83368 kbps
Actual Aggregate Tx Power: 0.9 dBm 12.8 dBm
================================================================================
====
VDSL Band Status U0 U1 U2
U3 U4 D1 D2 D3
Line Attenuation(dB): 3.1 14.3 20.8 N/A N/A 8.0 17.6
26.9
Signal Attenuation(dB): 3.1 13.6 20.4 N/A N/A 9.2 17.5
27.0
SNR Margin(dB): 11.0 10.8 10.9 N/A N/A 6.1
6.1 6.1
TX Power(dBm): -13.6 -29.2 0.7 N/A N/A 8.9
7.8 7.1
#

It will take a day or so for G.INP to be applied to the line mate, seen it a few times on Kitz, don't worry Leave the HG612 in place and G.INP will come.

I think that confirms you're on a Huawei alright. Maybe the roll out isn't finished?

I suspect you have interleaving on.

We could do with the output from xdslcmd info --stats

Include the long list of error stats at the end please so we can see a bit about the error rates. (xdslcmd info --show doesn't give those and are what I normally ask for).

http://forum.kitz.co.uk/index.php/topic,15295.0.html...

See his post.