I did ask plusnet for the line test GEA test to see if Vectoring is enabled or not? Plusnet cannot tell me if it was on or not. They not aware of any vectoring trial test from openreach?
But they notice my line was all the over the place but there is no sign of DLM trigger which it rather odd.
Edited by adslmax (Wed 02-Aug-17 12:13:06)
adslmax (knowledge is power)
Wed 02-Aug-17 12:34:57
Saw openreach engineer is working on my green cabinet and he told me he just putting a new card in and testing. I asked him about vectoring and g.fast. He say my cabinet is on trial of vectoring ongoing process but DLM will not affect in this trial stage. As for g.fast there is no timeframe slot for the time being.
My router has resync again:
adsl info --vectoring
adsl: ADSL driver and PHY status
Status: Showtime
Last Retrain Reason: 6
Last initialization procedure status: 0
Max: Upstream rate = 30843 Kbps, Downstream rate = 93285 Kbps
Bearer: 0, Upstream rate = 19999 Kbps, Downstream rate = 79999 Kbps
Bearer: 1, Upstream rate = 0 Kbps, Downstream rate = 0 Kbps
Vectoring state: 5
VCE MAC Address: 0:0:0:0:0:0
Total error samples Ethernet pkts sent: 0
Total error samples Ethernet pkts discarded: 0
Total error samples statuses sent: 0
Total error samples statuses discarded: 0
It's appear openreach trialing vectoring in most places but there is nothing on ispreview or thinkbroadband about this. Nothing on BT press release news.
All I can see so far that BT trialing:
new g.fast pod installing
vectoring test
SNR 3dB trial
g.INP on ECI cabinet trial
Edited by adslmax (Wed 02-Aug-17 12:39:19)
adslmax (knowledge is power)
Wed 02-Aug-17 12:46:04
I just noticed that very odd on downstream Errored Second was still zero but upstream Errored Second was very badly soaring to 778 so far after 6th resync. I think upstream is still on fast path while downstream still on interleaved (8)
I will keep monitoring it and updated if any change.
Pages in this thread: 
Print Thread
