It's mean your line has been resync 6 times!

In reply to a post by Bobby_Valentino:

a code for something else?

See the Kitz forum, this appears to be a reason code. 6 isn't listed, but could be something simple.
https://forum.kitz.co.uk/index.php?topic=10289.0

Quoted below.

Retrain Reason: asbokid has come up with the following based off the available broadcom source code (re-training in general is 'optional and vendor proprietary' according to the standard, so the following is probably only valid for broadcom chipsets, for more detail see the asbo's post):

Code:

Loss Of Framing (not receiving valid frame) : re-train reason code of 2.
Loss Of Signal (not receiving signal) : re-train reason code of 4.
Loss Of Power : re-train reason code of 8.
Loss Of Signal Quality : re-train reason code of 16.
Loss Of Margin : re-train reason code of 32.

In reply to a post by adslmax:

It's mean your line has been resync 6 times!

It is a reason code, not a count, so it does not mean 6 times.

In reply to a post by jchamier:

In reply to a post by adslmax:

It's mean your line has been resync 6 times!

It is a reason code, not a count, so it does not mean 6 times.

Thanks for confirming.

In reply to a post by jchamier:

In reply to a post by adslmax:

It's mean your line has been resync 6 times!

It is a reason code, not a count, so it does not mean 6 times.

I probably get mix up with this one below:

DSLAM type / SW version: BDCM:0xa4aa (164.170) / v0xa4aa
Modem/router firmware: AnnexA version - A2pv6F039g1.d24m
DSL mode: VDSL2 Profile 17a
Status: Showtime
Uptime: 1 day 3 hours 7 min 27 sec
Resyncs: 0 (since 9 May 2025 17:18:40)

and this one below:

adsl info --stats
adsl: ADSL driver and PHY status
Status: Showtime
Last Retrain Reason: 0
Last initialization procedure status: 0

In reply to a post by jchamier:

In reply to a post by Bobby_Valentino:

a code for something else?

See the Kitz forum, this appears to be a reason code. 6 isn't listed, but could be something simple.
https://forum.kitz.co.uk/index.php?topic=10289.0

Quoted below.

Retrain Reason: asbokid has come up with the following based off the available broadcom source code (re-training in general is 'optional and vendor proprietary' according to the standard, so the following is probably only valid for broadcom chipsets, for more detail see the asbo's post):

Code:

Loss Of Framing (not receiving valid frame) : re-train reason code of 2.
Loss Of Signal (not receiving signal) : re-train reason code of 4.
Loss Of Power : re-train reason code of 8.
Loss Of Signal Quality : re-train reason code of 16.
Loss Of Margin : re-train reason code of 32.

Looks quite likely that there is a Reason Byte and the Reason Code is a combination of bits.

So Reason Code 6 = Reason Code 4 + Reason Code 2