There are no compoments on a slave.
The brown printed circuit board of the slave socket shown in photo:
http://www.boliston.co.uk/temp/extension_tidied.jpg
shows what look like symbols for "resistors" or some sort of component between terminal #4 & terminal #5 and also something else between terminal #3 & terminal #2.
I notice that there are 3 retaining screws on the PCB so I might have a look to see if there are any components soldered to the rear of the board.
The main reason I'm concerned about noise at the moment is that BT have put me on a "banded profile" of about 30% of the speed that my line will support and the reason they put people on banded profiles is errors on the line caused by noise. I'm hoping that if I can reduce noise then BT will remove the banded profile.
I seem to be getting about 20 errors per hour at the moment but I'm not sure what counts as "a lot of errors"
(stats from my router since last reboot)
P-660HW-T> wan adsl perfdata
near-end FEC error fast: 20
near-end FEC error interleaved: 0
near-end CRC error fast: 27
near-end CRC error interleaved: 0
near-end HEC error fast: 24
near-end HEC error interleaved: 0
far-end FEC error fast: 0
far-end FEC error interleaved: 0
far-end CRC error fast: 65504
far-end CRC error interleaved: 0
far-end HEC error fast: 0
far-end HEC error interleaved: 0
ADSL uptime 1:11:08
P-660HW-T> wan adsl chandata
DSL standard: ADSL2 DELT
near-end interleaved channel bit rate: 0 kbps
near-end fast channel bit rate: 4544 kbps
far-end interleaved channel bit rate: 0 kbps
far-end fast channel bit rate: 1080 kbps
P-660HW-T> wan adsl linedata near
noise margin downstream: 19 db
output power upstream: 11 db
attenuation downstream: 30 db
P-660HW-T> wan adsl linedata far
noise margin upstream: 6 db
output power downstream: 0 db
attenuation upstream: 17 db