|
|
10 years ago my phone wiring was as follows:
BT Master - 2 extensions [1 downstairs, 1 upstairs] upstairs one was wired by myself from IDC terminals.
I then had ADSL installed [convert from Home Highway] so was installed by BT
When BT engineer came to install ADSL [upstairs] all he did was put an additional Filtered Master socket in the line I had installed.
So wiring is NOW as follows:
BT Master - downstairs extension [filter not required]
|_ upstairs - Filtered Master
I get fairly good stats BUT the Question is would I get better stats by converting the original Master to the Filtered master and moving the Router/Modem downstairs and running Cat5e cable upstairs to the Switch
Bob
SKY Customer WRBRIX
|
|
|
|
Probably, yes. Have you compared your router stats at the current extension to what you get when connected to the test socket behind the BT Master (Assuming it's an NTE5 type)?
Instead of running Cat5 about the place, have you considered going wireless or using HomePlugs as an alternative?
|
|
|
10 years ago my phone wiring was as follows: That arrangement sounds the same as mine although I assumed that the engineer had effectively moved the master. I assumed that because there's a test socket behind the faceplate in my study.
I wouldn't have thought that using the downstairs socket would make much difference unless there's a lot of ambient noise and/or the cable goes a long way.
In my case I'm 2.5km from the exchange and the cable extension is about 10m. It is round the outside of the house though and I do have a slightly noisy line (ran at 12db on IPStream and only stable at 9db with Bethere). I sync at over 13Mb which according to a checker on Bethere is above average for my 34db attenuation.
Edited by Andrue (Mon 18-May-09 12:04:43)
|
|
Register (or login) on our website and you will not see this ad.
|
|
|
A couple of photos of the wiring wouldn't go amiss.
From the description it sounds like the BT eng might of back wired the downstairs socket from the new adsl master. This has been known to cause issues as you are running unfiltered and filtered in the same cable with the addition of the ring wire.
Dave
|
|
|
No I haven't tested it, but as stated I get quite good stats at the moment downloads from newsgroups come thru @ 1 to 1.2 MB/s and that's on a 31db Line Att and 7.6db SNR, and I prefer to run the Cat5, it's a lot cheaper
Probably, yes. Have you compared your router stats at the current extension to what you get when connected to the test socket behind the BT Master (Assuming it's an NTE5 type)?
Instead of running Cat5 about the place, have you considered going wireless or using HomePlugs as an alternative?
Bob
SKY Customer WRBRIX
|
|
|
Looks like it won't make a lot of difference as my Att is 31db and I'm getting just over 1 MB/s on downloads, which is very similar to yours.
Thanks for your input
Bob
SKY Customer WRBRIX
|
|
|
He didn't touch the downstairs socket at all, he just cut the wire to my phone extension upstairs and the wired in the filtered Master socket, I did ask him at the time if the downstairs phones would also be filtered and he told me they would be.
I disconnected the ring wires from the Old Master when I originally put in the upstairs extension so that's not an issue, although not as an engineer I did work for BT International when it was the PO so i do know a [little] about the connections.
Bob
SKY Customer WRBRIX
|
|
|
Looks like it won't make a lot of difference as my Att is 31db and I'm getting just over 1 MB/s on downloads, which is very similar to yours.
Thanks for your input This is amongst the best I've seen:
http://www.thinkbroadband.com/speedtest/results/id/1...
Note the time:Gotta appreciate a good ISP
It wasn't so good around Christmas but Be upgraded the link eventually.
|
|
|
These are mine as of a few minutes ago and that's with SKY
http://www.thinkbroadband.com/speedtest/results/id/1...
Bob
SKY Customer WRBRIX
|
|
|
These are mine as of a few minutes ago and that's with SKY
http://www.thinkbroadband.com/speedtest/results/id/1... Not bad as long as it doesn't drop in the evenings and I seem to recall that you guys are free of usage limits like us. With Be you'd likely be getting over 12Mb from TBB speedtest with 31db. If you choose the speed profile (3db noise margin) you might hit 13Mb.
If I had to move I'd probably consider Sky because I could bundle it with Sky+ and reduce the cost. I don't really need the speed most of the time but that consistency is nice. I find that I get very annoyed if it isn't what I expect on the rare occasions when I need it - I think I've been spolied by Be
Edited by Andrue (Mon 18-May-09 15:31:16)
|
|
|
In order to provide a filtered connection at the old master the eng would have needed to provide a connection from the filtered side of the ADSL master so will most likely have back wired, otherwise you would need a filter on the old master.
Dave
|
|
|
It's the main reason I'm with Sky, I have Sky+HD, multiroom and BB so i only pay a tenner for the BB until next year when it goes up to fifteen quid, another couple of years and I will be dumping a lot of things when I retire to keep the costs down to what I will be able to afford on a pension
Bob
SKY Customer WRBRIX
|
|
|
I'll have to have a look at the wiring inside the Filtered Master, but that won't happen until the end of the week when I have the time.
If it is backwired, I've not had any problems with it since it was installed and that goes back to when they were allowing conversions from HH to ADSL, and Nildram didn't belong to Pipex and you only got 1Mb max, and we called that FAST
Thanks for your input
Bob
SKY Customer WRBRIX
|
|
|
It's the main reason I'm with Sky, I have Sky+HD, multiroom and BB so i only pay a tenner for the BB until next year when it goes up to fifteen quid, another couple of years and I will be dumping a lot of things when I retire to keep the costs down to what I will be able to afford on a pension  Heh, well I hope you enjoy your retirement
|