General Discussion
  >> Fibre Broadband


Register (or login) on our website and you will not see this ad.


Pages in this thread: 1 | [2] | (show all)   Print Thread
Standard User deleted
(deleted) Thu 11-May-17 13:01:48
Print Post

Re: FTTC accepting orders, but not for me


[re: MrSaffron] [link to this post]
 
Cheers for all the replies guys.

I'll keep an eye, and update in case this helps anyone else out.
Standard User PaulKirby
(knowledge is power) Thu 11-May-17 13:20:58
Print Post

Re: FTTC accepting orders, but not for me


[re: RobertoS] [link to this post]
 
In reply to a post by RobertoS:
@Paul - The exchange is around 1.4km from the cabinet, and the cabinet is just over 200m from my house. Measurements are in a straight line by the way.

Well I found the OP exchange and followed the route to the OP Postcode and I did see loads of PCP and Fibre Cabinets on the way, most were other cabinets, but there were some with no numbers on them, so maybe it was one of those.

But saying that, both the BT DSL Checker and the Where and when page say that nobody can get it and that they was all too far from the cabinet, granted I didn't check all addresses.

Paul

BTBroadband - Infinity 4 - 310Mbps (down), 31Mbps (up)
TBB Speedtest | BQM #4 Linksys WRT 3200 ACM
Standard User RobertoS
(elder) Thu 11-May-17 13:48:05
Print Post

Re: FTTC accepting orders, but not for me


[re: deleted] [link to this post]
 
Just realised you have your full address on that uploaded table. Best to delete that and substitute one with just the exchange and cabinet number on that line.

A description or street photo of where the phone cabinet is would be useful as well as someone may know more about it. A pic of the fibre cab is unnecessary.

My broadband basic info/help site - www.robertos.me.uk. Domains, site and mail hosting - Tsohost.
Connection - AAISP Home::1 80/20. Sync 63086/13719Kbps @ 600m. BQMs - IPv4 & IPv6

Edited by RobertoS (Thu 11-May-17 13:49:51)


Register (or login) on our website and you will not see this ad.

Administrator MrSaffron
(staff) Thu 11-May-17 15:59:34
Print Post

Re: FTTC accepting orders, but not for me


[re: PaulKirby] [link to this post]
 
believe its a fairly new cabinet so you may not see it on street view at all

The author of the above post is a thinkbroadband staff member. It may not constitute an official statement on behalf of thinkbroadband.
Standard User deleted
(deleted) Thu 11-May-17 17:17:36
Print Post

Re: FTTC accepting orders, but not for me


[re: MrSaffron] [link to this post]
 
Yeah that is correct, the cab is fairly new and isn't on Google Street View.
The cab is located on the corner of these roads, if that helps with anything.
Administrator MrSaffron
(staff) Thu 11-May-17 17:27:10
Print Post

Re: FTTC accepting orders, but not for me


[re: deleted] [link to this post]
 
And within 5 metres of where I thought it should be smile

The author of the above post is a thinkbroadband staff member. It may not constitute an official statement on behalf of thinkbroadband.
Standard User deleted
(deleted) Thu 11-May-17 20:28:11
Print Post

Re: FTTC accepting orders, but not for me


[re: deleted] [link to this post]
 
A good marker that the cabinet has gone live is in the last section. When "VDSL multicast" is available, then FTTC is normally.

It could be that the DP doesn't have the right data stored to allow an estimate, so the OP doesn't get an estimate. Everyone using the same DP would be in the same boat.

It is probably worth checking some other properties on the same cab, but on different DPs.
Standard User PaulKirby
(knowledge is power) Fri 12-May-17 01:28:39
Print Post

Re: FTTC accepting orders, but not for me


[re: deleted] [link to this post]
 
Yeah I saw that one as well between the 3rd and 4th car, but due to Google Maps not been there yet I was unable to check the number.

And also there are loads of different types of cabinets for the area, so I wasn't too sure what cabinet it really was.

Paul

BTBroadband - Infinity 4 - 310Mbps (down), 31Mbps (up)
TBB Speedtest | BQM #4 Linksys WRT 3200 ACM
Standard User PaulKirby
(knowledge is power) Fri 12-May-17 01:32:12
Print Post

Re: FTTC accepting orders, but not for me


[re: MrSaffron] [link to this post]
 
In reply to a post by MrSaffron:
believe its a fairly new cabinet so you may not see it on street view at all

Well I normally check for the PCP first in the area that has the highest FTTC speeds listed and then just walk about on google maps, I virtually walked past that area 5 times.

Sadly the google car hasn't been in that area, so I was unable to see the PCP number if there is one printed on it.

Paul

BTBroadband - Infinity 4 - 310Mbps (down), 31Mbps (up)
TBB Speedtest | BQM #4 Linksys WRT 3200 ACM
Standard User deleted
(deleted) Mon 22-May-17 10:21:55
Print Post

Re: FTTC accepting orders, but not for me


[re: deleted] [link to this post]
 
Just an update, as of Friday 19th May I was able to order Fibre Broadband. The Openreach checker had updated, and so did the dslchecker site.

For anyone in a similar situation - a silver lock was installed on to the fibre cabinet on 5th May, the Openreach & dslchecker sites were updated (although I wasn't able to order fibre) on 10th May, finally on 19th May, I was able to order fibre. So 2 weeks from when the silver lock was fitted - although this isn't gospel and can be different for everyone.
Pages in this thread: 1 | [2] | (show all)   Print Thread

Jump to