Technical Discussion
>> Home Networking, Internet Connection Sharing, etc.

These posts have been archived and can no longer be replied to or modified.
	Print Thread

sji
(newbie) Sun 13-Jul-08 19:25:14

ST510 multi static IP. NAT possible also?

[link to this post]

Hello everyone,

I'm running multiple static IPs with my aging speedtouch 510 v3 and would like to add NAT to the configuration.

Is it possible to enable NAT on the 510 whilst running with the static IPs?

Many thanks,

Stephen

Rockh
(eat-sleep-adslguide) Sun 13-Jul-08 21:18:01

Re: ST510 multi static IP. NAT possible also?

[re: sji] [link to this post]

Long time since I used a 510v3 but IIRC it's not possible unless it can be done via the CLI. The 510v4 had the facility but it wasn't until a couple of firmware releases after it's introduction.

Dave

Sandgrounder
(knowledge is power) Mon 14-Jul-08 11:35:46

Re: ST510 multi static IP. NAT possible also?

[re: sji] [link to this post]

They are a bit pricey - but a DrayTek router will do what you want.

Line One:- Zen - DrayTek Vigor 2600VG
Line Two:- EntaNet - DrayTek Vigor 2600

sji
(newbie) Mon 14-Jul-08 23:20:08

Re: ST510 multi static IP. NAT possible also?

[re: Sandgrounder] [link to this post]

I figured the Draytek would do the job, but hoped I could wrangle something from my old ST510.

I've bitten the bullet and ordered a Draytek 2800 today.

Thanks for the replies folks.

Stephen

sji
(newbie) Wed 16-Jul-08 23:10:32

Re: ST510 multi static IP. NAT possible also?

[re: sji] [link to this post]

update:

The 2800 arrived today and is performing nicely.

Stephen

Sandgrounder
(knowledge is power) Wed 16-Jul-08 23:15:00

Re: ST510 multi static IP. NAT possible also?

[re: sji] [link to this post]

Line One:- Zen - DrayTek Vigor 2600VG
Line Two:- EntaNet - DrayTek Vigor 2600

Print Thread

Jump to