Finished the testing and a bit confused.
1) Swapped the blanking plate with the NTE5 plate (the blanking plate covered the original BT Infinity socket)
2) Plugged in the OR modem into the NTE5 plate (no DSL SIGNAL)
3) Plugged in a landline phone into the socket below (no dial tone)
4) Plugged in a landline phone into the master socket (no dial tone)
5) Rang the landline number rang out but the phone did not ring (as expected)
6) Plugged in a landline phone into the ex VM master socket and got a dial tone
7) Rang the landline number and the phone rang
8) Swapped back the faceplates and blanking plates
9) Plugged in a landline phone into the phone socket (ex VM) phone rings and there is a dial tone
10) Plugged in the OR modem and no DSL signal into the NTE5 socket
I would of expected both sockets to work however the OLD BT master socket where the phone line comes into seems dead?? i.e no dial tone and no DSL whereas the Ex.VM socket has a dial tone but again no DSL.
Any further suggestions would be much appreciated if anyone can think of any.
Thanks for all the help as well guys its very much appreciated.
Edited by deleted (Wed 06-Jan-16 18:27:22)